Our site uses cookies necessary for its proper functioning. To improve your experience, other cookies may be used: you can choose to disable them. This can be changed at any time via the Cookies link at the bottom of the page.
Standards for PE100 water & gas pipe Both ISO and EN Standards are available covering PE100 pipe. The relevant Standards are: ISO 4427-2: Plastics piping systems. Polyethylene pipes & fittings for...
PE & HDPE Pipe PE100 is the third generation of pipe grade PE. It has an optimum balance of three key properties: Minimum Required Strength (MRS) – this provides long-term strength and creep...
Simplicity or consistency The simplest way for any polymer producer to operate is to produce natural pellets for a wide range of applications...
PE100+ Quality Materials List is valid until December 2022. It is available online and a PDF version can be downloaded.
PE100 can be manufactured in a wide range of polyethylene pipe diameters from 16mm to 2000mm. Even larger diameters are possible with the development...
SDR pipe : "Standard Dimensional Ratio" The SDR pipe is the "Standard Dimensional Ratio" and refers to the geometry of the pipe. SDR is defined as...
Creep rupture strength - Internal pressure test Constant internal pressure at constant temperature The internal pressure test is standardised in ISO...
PIPE BURSTING / SPLITTING - TECHNIQUE Pipe bursting and pipe splitting are trenchless methods used to replace existing pipelines with PE100 in the...
PIPE REAMING - TECHNIQUE Pipe reaming, also known as pipe eating, is a trenchless pipe replacement technique that removes the host pipe while at the...
Requirements of the PE 100+ Association Firstly, the ready made compounds must conform to EN 1555-1 and ISO 4437, or EN 12201-1 and ISO 4427. Fully...
Webinar : Benefits of PE100+ Material and their use in Trenchless TechnologyOn march 10th, was held the PE 100+ ASSOCIATION first webinar. The webinar was a great success and attracted a large audience.
