Our site uses cookies necessary for its proper functioning. To improve your experience, other cookies may be used: you can choose to disable them. This can be changed at any time via the Cookies link at the bottom of the page.


PE technical guidance
HDPE Pipe technical guidance (High quality Polyethylene Pipes)
 

How can damaged PE pipe be repaired?

Quick access

The method of repairing damaged PE pipe depends upon the degree of damage sustained. Localised damage may be repaired by use of an electrofusion saddle or clamp fixed around the damaged area. Such a repair may not be suitable where gas or other flammable fluid is present in the pipe, due to the heat generated in the fusion process. PE encapsulation techniques have recently been developed and may be suitable for localised repairs. Information on these techniques can be obtained from the pipe manufacturers.

More extensive damage will require the section of pipe to be cut out and replaced. This is a relatively simple process, firstly isolating the damaged section by the use of squeeze-off tools, cutting out the section and replacing with new pipe using electrofusion couplers to tie-in the sections. It is important that the replacement section is of suitable diameter and pressure rating to maintain the integrity of the pipeline.

In all cases reference should be made to local or national codes of practice and all health and safety procedures should be closely followed.

Last update Thursday 31 May 2018

Members of the Association

BOREALISBOROUGEFormosa Plastics CorporationHanwha TotalEnergiesINEOS O&PIRPCKorea Petrochemical IND. Co., LTD (KPIC)LyondellBasellPetroChina Dushanzi Petrochemical CompanyPRIME POLYMERSABICSCG Chemicals & Thai PolyethyleneSinopecTASNEE
TOP