Our site uses cookies necessary for its proper functioning. To improve your experience, other cookies may be used: you can choose to disable them. This can be changed at any time via the Cookies link at the bottom of the page.


Grade: MRS

HDPE Pipe technical guidance (High quality Polyethylene Pipes)
 

What is the meaning of the designations PE80 and PE100?

PE80 and PE100 meaning The designations PE80 and PE100 are based on the long-term strength of the respective materials, known as the minimum required strength (MRS) in accordance with ISO 12162. The designations are: Material Designation Minimum Required Strength (MRS)MPa PE100 10.0 PE80 8.0 Minimum Required Strength (MRS) The MRS is determined by performing regression analysis in accordance with ISO 9080 on the test data from the results of long-term pressure testing. The regression analysis...

How do these designations relate to MDPE and HDPE?

Prior to the adoption of international standards (CEN, ISO) PE pipe materials were more commonly designated by their density within the range associated with PE i.e. Low Density PE (LDPE), Medium Density PE (MDPE) and High Density PE (HDPE). The reference to density gave an indication of the material strength. For example HDPE pipe had a higher long term strength or minimum required strength (MRS) than LDPE. But this gave no indication as to other long term properties, such as slow crack growth...


Members of the Association

BOREALISBOROUGEFormosa Plastics CorporationHanwha TotalEnergiesINEOS O&PIRPCKorea Petrochemical IND. Co., LTD (KPIC)LyondellBasellPetroChina Dushanzi Petrochemical CompanyPRIME POLYMERSABICSCG Chemicals & Thai PolyethyleneSinopecTASNEE

Top articles

PE100+ position letter on ANPT

(SCG) resistance on pipes for pressure applications since many years. With the introduction of PE 100-RC materials in EN 1555, EN 12201 and ISO...

PE 100-RC+ Quality Materials List

PE 100-RC+ materials have become an essential and well established sub-family of PE 100 compounds. They have a higher stress crack resistance and...

PE 100+ association leads permeation tests for H2 ready certification

A number of gas utilities and grid owners have approached the PE 100+ association regarding the suitability of PE 100 pipe systems for the...

Why choose PE compounds for pressure pipe ?

Simplicity or consistency The simplest way for any polymer producer to operate is to produce natural pellets for a wide range of applications...

PE100+ Quality Materials List

PE100+ Quality Materials List is valid until December 2024. It is available online and a PDF version can be downloaded at the bottom of this page.

What range of pipe diameters is available?

PE100 can be manufactured in a wide range of polyethylene pipe diameters from 16mm to 2000mm. Even larger diameters are possible with the development...

What is SDR pipe and how does it influence the pressure rating of the pipe?

SDR pipe : "Standard Dimensional Ratio" The SDR pipe is the "Standard Dimensional Ratio" and refers to the geometry of the pipe. SDR is defined as...

Standard test methods

Creep rupture strength - Internal pressure test Constant internal pressure at constant temperature The internal pressure test is standardised in ISO...

Pipe Bursting and Splitting

PIPE BURSTING / SPLITTING - TECHNIQUE Pipe bursting and pipe splitting are trenchless methods used to replace existing pipelines with PE100 in the...

TOP