Our site uses cookies necessary for its proper functioning. To improve your experience, other cookies may be used: you can choose to disable them. This can be changed at any time via the Cookies link at the bottom of the page.


Pipe Rehabilitation Methods

HDPE Pipe technical guidance (High quality Polyethylene Pipes)
 
Die Drawing

Technique For all close-fit PE lining methods, during the reduction process the outside diameter of the PE100 pipe is reduced to less than the minimum bore diameter of the host pipe. Once the PE100...

Close Fit Lining: Roller Reduction (Rolldown)

For all close-fit PE lining methods, during the reduction process the outside diameter of the PE100 pipe is reduced to less than the minimum bore diameter of the host pipe. Once the PE100 liner pipe...

Close Fit Lining: Fold and Form Lining

TECHNIQUE All PE close fit lining technologies effectively reduce the original diameter of the PE liner pipe prior to insertion, to facilitate pulling it in to the host pipe, followed by a reversion...

Slip lining

SLIPLINING - TECHNIQUE Slip-lining is perhaps the oldest of all trenchless techniques. It involves the insertion of a new PE100 liner pipe of standard diameter and SDR into an existing pipe. Under...

Pipe Bursting and Splitting

PIPE BURSTING / SPLITTING - TECHNIQUE Pipe bursting and pipe splitting are trenchless methods used to replace existing pipelines with PE100 in the same alignment without physically removing the...

Pipe Reaming

PIPE REAMING - TECHNIQUE Pipe reaming, also known as pipe eating, is a trenchless pipe replacement technique that removes the host pipe while at the same time installing a new replacement pipe. Pipe...

Pipe Extraction

TECHNIQUE Pipe extraction is a trenchless pipe replacement technique that removes existing pipes for disposal while at the same time installing a new replacement PE100 pipe. There are several systems...


Members of the Association

BOREALISBOROUGEFormosa Plastics CorporationHanwha TotalEnergiesINEOS O&PIRPCKorea Petrochemical IND. Co., LTD (KPIC)LyondellBasellPetroChina Dushanzi Petrochemical CompanyPRIME POLYMERSABICSCG Chemicals & Thai PolyethyleneSinopecTASNEE

Top articles

PE100+ position letter on ANPT

(SCG) resistance on pipes for pressure applications since many years. With the introduction of PE 100-RC materials in EN 1555, EN 12201 and ISO...

PE 100-RC+ Quality Materials List

PE 100-RC+ materials have become an essential and well established sub-family of PE 100 compounds. They have a higher stress crack resistance and...

PE 100+ association leads permeation tests for H2 ready certification

A number of gas utilities and grid owners have approached the PE 100+ association regarding the suitability of PE 100 pipe systems for the...

Why choose PE compounds for pressure pipe ?

Simplicity or consistency The simplest way for any polymer producer to operate is to produce natural pellets for a wide range of applications...

PE100+ Quality Materials List

PE100+ Quality Materials List is valid until December 2024. It is available online and a PDF version can be downloaded at the bottom of this page.

What range of pipe diameters is available?

PE100 can be manufactured in a wide range of polyethylene pipe diameters from 16mm to 2000mm. Even larger diameters are possible with the development...

What is SDR pipe and how does it influence the pressure rating of the pipe?

SDR pipe : "Standard Dimensional Ratio" The SDR pipe is the "Standard Dimensional Ratio" and refers to the geometry of the pipe. SDR is defined as...

Standard test methods

Creep rupture strength - Internal pressure test Constant internal pressure at constant temperature The internal pressure test is standardised in ISO...

Pipe Bursting and Splitting

PIPE BURSTING / SPLITTING - TECHNIQUE Pipe bursting and pipe splitting are trenchless methods used to replace existing pipelines with PE100 in the...

TOP